FT Cabinetry Sarasota
Freshly tiled shower wall with large porcelain tile and a linear niche in a Sarasota bathroom

Bathroom Remodeling

Bathroom & Shower Tile Installation in Sarasota, FL

Tile installation in Sarasota bathrooms only lasts when the layers behind it are right: a waterproofing membrane, a flat and sound substrate, and a shower floor sloped to the drain. We plan shower, wall and floor tile as part of a bathroom remodeling project, so the tile layout lines up with the custom vanity, niches and fixtures shown in your 3D presentation.

  • 5.0★ on Google · 28 reviews
  • Custom-designed modular cabinets
  • In-home technical visit & 3D design
  • Sarasota location on 6th St

This page explains how bathroom tile goes in, which materials suit a humid Gulf Coast house, and what drives cost. Shower pans, drain moves and valve changes are permitted plumbing work done by a plumber licensed in Florida, and we are clear about that division from the first visit.

What Our Bathroom Tile Planning Covers

Tile is the finish you see, but most of a tile job is preparation: tearing out what failed, fixing the surface under it and waterproofing the shower before a single piece is set. Our role is to plan that sequence with you and fit the vanity, niches and trim to it, so the room is drawn once and built once.

Shower pan and drain work stays with a Florida-licensed plumber under permit. The planning items below are part of every bathroom where tile changes:

  • Measurement of shower walls, floor area and wall heights at the technical visit
  • A tile layout shown in 3D with the vanity, mirror, niches and fixtures
  • Guidance on tile material, size, finish and grout for wet and dry areas
  • A written list of substrate and waterproofing steps for the shower
  • Removal planning for existing tile and damaged backer board
  • Coordination of tile timing with the plumber, glass installer and our cabinet installation
  • Transitions planned between bathroom tile and adjoining floors

Do You Waterproof Behind Shower Tile?

Every shower needs it, because tile and cement grout let water through. What stops water from reaching the framing is the layer beneath. The two common approaches are compared below.

Shower waterproofing methods
MethodHow it worksNotes
Sheet membraneA fabric or plastic sheet set in thin-set over the backer board, with sealed seams and cornersConsistent thickness; seams and corners need careful overlap
Liquid-applied membraneA coating rolled or brushed on in two or more coats to a specified thicknessEasy around niches and valves; thickness must be checked
Traditional mortar bed with linerA sloped mortar bed over a waterproof pan linerLong-established method; heavier and slower to cure
Shower walls and niche covered in waterproofing membrane before tile in a Sarasota bathroom
Walls, niche and pan covered in a waterproofing membrane before any tile is set.

The shower floor must slope toward the drain, typically about a quarter inch per foot, so water never sits under the tile. Niches need their own slight slope and full membrane coverage. Because the pan connects to the drain, it is permitted plumbing work in most jurisdictions.

Why Bathroom Tile Fails in Sarasota Homes

Tile itself rarely wears out. What fails is the bond beneath it or the water barrier behind it, and local conditions speed both along:

  • Slab movement: most homes here sit on concrete slabs, and a hairline slab crack will travel straight through rigid floor tile set without an uncoupling layer.
  • Shut-up summers: seasonal homes closed with the air conditioning off let grout and caulk mildew, and swelling backer board can loosen wall tile.
  • Storm water: floor tile that sat in floodwater after Helene or Milton may look intact while the drywall, baseboard and vanity base around it hold moisture.
  • Dated wet areas: pastel 1970s and 1980s tile, often set over drywall or a failing mortar bed, that sounds hollow when tapped.
  • Condo shortcuts: hard floors laid without the sound-control underlayment many associations now require, which can mean redoing the floor after a neighbor complains.

Spotting which of these applies decides whether you need regrouting, a new floor or a full tear-out to the studs.

Which Tile Holds Up Well in Florida Showers?

Porcelain is the most practical choice for most Southwest Florida showers. It absorbs very little water, resists the constant humidity, and comes in stone, wood and concrete looks. Natural stone works too but needs sealing and gentler cleaners.

  • Porcelain: dense, low absorption, suitable for walls and floors. Choose a textured or matte finish for the shower floor.
  • Ceramic: fine for walls and low-traffic floors; softer than porcelain.
  • Glass and glazed mosaics: good for niches and accents; small sizes add grout lines, which help grip on a floor.
  • Marble and travertine: attractive but porous; plan on sealing and pH-neutral cleaning.
Porcelain shower walls with a small matte mosaic floor in a humid Southwest Florida bathroom
Porcelain wall tile paired with a small mosaic floor that adds grip underfoot.

Grout matters as much as tile. Many owners choose epoxy or high-performance grout in the shower because it resists staining and mildew better than standard cement grout.

Large-Format Tile and Floor Tile Installation

Large-format tile, generally any tile with a side of 15 inches or more, gives a calm look with fewer grout lines. It also exposes every flaw in the surface beneath. Industry standards call for a much flatter substrate under large tile than under small tile, so walls may need leveling and floors may need patching before setting.

Large-format porcelain floor tile laid in a one-third offset in a Sarasota-area bathroom
Large-format floor tile in a one-third offset, which helps keep edges even.

On concrete slab floors, tile installers check for cracks and moisture and may add an uncoupling membrane to isolate the tile from slab movement. Floor tile is laid before a wall-hung vanity is mounted and, in most cases, before a floor-standing one, so finishes continue cleanly. For the cabinet side of the room, see how we size custom bathroom vanities.

Tile Replacement in Sarasota: Cost and Planning

We do not publish per-square-foot prices. After measuring, we provide a written itemized quote for our scope. These factors shape the cost of bathroom tile:

  • Removal of the existing tile and whether the backer board behind it is damaged
  • Substrate work: leveling, new backer board, uncoupling membranes
  • Waterproofing method and shower size
  • Tile size, material and pattern; herringbone and mosaics take longer to set
  • Niches, benches, curbs and trim pieces
  • Plumbing changes, which add permitted, licensed work
  • Grout type: epoxy or high-performance grout costs more than standard cement grout
  • Condo rules, such as required sound-control underlayment under floor tile and set work hours
  • Door clearances and transitions when new tile raises the floor height
  • Hauling heavy demolition debris out of upper-floor units
Old bathroom wall tile removed to expose backer board for inspection in a Florida home
Old tile removed to check the backer board and framing for water damage.

If tile is part of a larger change, such as a tub-to-shower conversion or a full master bathroom remodel, the tile layout is designed with the rest of the room. For kitchens, see backsplash installation.

Planning new shower or floor tile? Call (239) 545-0550 to set up a measurement visit.

Call (239) 545-0550

Tile, Permits and Licensing in Sarasota County

Setting tile is not one of the state-licensed trades in Chapter 489, Florida Statutes, but the shower pan, drain and valve are plumbing work for a licensed plumber who pulls the permit. Expect an inspection of the pan liner before it is covered. Some local offices also register specialty contractors such as tile setters, so ask before work starts.

Permits come from the City of Sarasota Building Division inside city limits and the Sarasota County Building Division in unincorporated areas; Venice, North Port and Manatee County have their own departments. Verify the plumber at myfloridalicense.com, and condo owners should get the association’s written approval, including its underlayment rule, before ordering tile.

How We Plan Tile Installation in Sarasota Bathrooms

  1. 1

    Measure and inspect

    At the technical visit we measure tiled areas and note soft spots, cracked grout or loose tile that suggest water behind the wall.

  2. 2

    Choose materials

    We review tile size, material, finish and grout for each area: shower walls, shower floor and main floor.

  3. 3

    Lay it out in 3D

    The tile layout is shown with the vanity and fixtures so grout lines, niches and edges align.

  4. 4

    Sequence the trades

    Demolition, plumbing, waterproofing, tile, glass and cabinet installation are put in order, with licensed plumbing under permit.

  5. 5

    Install and finish

    Delivery and installation of the vanity and countertop follow the tile, so cabinets sit on finished floors.

Why Plan Tile and Cabinets Together With FT Cabinetry

One design for the room

Tile, vanity and storage are planned in the same 3D presentation, made with specialized design software.

Cabinetry is our specialty

Our custom-built modular vanities are sized to finished tile dimensions, not rough walls.

Clean installations

Google reviewers mention installers who left the home clean and tidy; we hold a 5.0 rating across 28 reviews (August 2026).

Plain answers about scope

At the first visit we tell you which tile and plumbing items sit with a tile setter or licensed plumber, and how our cabinet install fits around them.

Sizes taken from the room

Measurements come from the technical visit, so tile edges and vanity sides meet where the drawing says.

What homeowners say on Google

5.0★ average from 28 Google reviews · Read all reviews

★★★★★
“I recently worked with … FT Cabinetry for my kitchen remodel, and I am thrilled with the results! The team was professional, attentive, and helped bring my vision to life. The quality of the cabinetry is outstanding, showcasing excellent craftsmanship and materials. Installation was smooth and efficient, leaving my home clean and tidy.”
Tatiane A. · Google review · 2025
★★★★★
“Impeccable work! Super professional!”
Silvania F. · Google review · 2025 · translated from Portuguese by Google
★★★★★
“Professional and knowledgeable. I would recommend them to anyone.”
Chad P. · Google review · 2025

Where we provide tile installation

We plan bathroom tile and cabinet projects across Sarasota, Manatee and Charlotte counties, including The Meadows, Gulf Gate, Venice and Bradenton.

See every community we serve

Request a quote for tile installation

The quickest way to start is a call to (239) 545-0550. Prefer to write? Send the basics and we will call you back.

Prefer to talk? (239) 545-0550

Tile Installation: common questions

Which tile holds up well in Florida showers?

Porcelain is the most practical choice for most Florida showers because it absorbs very little water and handles daily humidity. Use a matte or textured finish on the floor for grip. Natural stone works with regular sealing. At the technical visit we look at your ventilation and cleaning habits before recommending a material.

Do you waterproof behind shower tile?

Yes, every shower plan includes a waterproofing layer, either a sheet membrane or a liquid-applied membrane, over the walls and pan, with the floor sloped to the drain. The pan and drain connection are permitted plumbing work handled by a Florida-licensed plumber, and we sequence tile after that work passes inspection.

Can you tile the whole house or only bathrooms?

We plan tile as part of bathroom and kitchen projects, where it ties into the cabinetry we design and install. If you are considering whole-house flooring, mention it at the technical visit and we will tell you plainly whether it fits our scope or whether a flooring specialist suits the job better.

Can new tile go over old tile?

On some floors it can, if the old tile is flat, firmly adhered and the added height works with doors and transitions. In showers, tiling over existing tile is generally not advised because you cannot inspect or replace the waterproofing behind it. We check the existing surfaces at the visit before recommending either approach.

How do I know if water is behind my shower tile?

Common signs include cracked or crumbling grout, loose or hollow-sounding tiles, staining at the base of the wall, peeling paint in the next room and a musty smell. In Sarasota’s humidity, mold can develop behind tile without showing on the surface. If you see these signs, plan for removal rather than regrouting.

Related services

Helpful guides

Planning tile installation?

Start with a technical visit at your home and a 3D design you can review before anything is ordered.

FT Cabinetry Sarasota · 2235 6th St, Sarasota, FL 34237

Call Now (239) 545-0550Request a Quote